HP 3100 Series User Manual

109
Port type
Actions (in the inbound direction)
Actions (in the outbound
direction)
Untagged frame Tagged frame
Trunk
Checks whether the
PVID is permitted on the
port:
• If yes, tags the
frame with the PVID
tag.
• If not, drops the
frame.
• Receives the frame if its
VLAN is carried on the
port.
• Drops the frame if its
VLAN is not carried on
the port.
• Removes the tag and
send the frame if the
frame carries the PVID tag
and the port belongs to
the PVID.
• Sends the frame without
removing the tag if its
VLAN is carried on the
port but is different from
the PVID.
Hybrid
Sends the frame if its VLAN is
carried on the port. The frame
is sent with the VLAN tag
removed or intact depending
on your configuration via the
port hybrid vlan
command.
This is true of the PVID.
Assigning an access port to a VLAN
You can assign an access port to a VLAN in VLAN view, interface view (including Layer 2 Ethernet
interface view, and Layer 2 aggregate interface view), or port group view.
To assign one or multiple access ports to a VLAN in VLAN view:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id
If the specified VLAN does not exist, this
command creates the VLAN first.
3. Assign one or a group of
access ports to the VLAN.
port
interface-list By default, all ports belong to VLAN 1.
To assign an access port (in interface view) or multiple access ports (in port group view) to a VLAN:
Step Command Remarks
1. Enter system view.
system-view
N/A

HP 3100 Series Specifications

General

Layer	Layer 2
Jumbo Frame Support	Yes
Switching Capacity	8.8 Gbps
MAC Address Table Size	8000 entries
Management	Web interface, SNMP, CLI
Operating Temperature	0 to 45°C (32 to 113°F)
Operating Humidity	10% to 90% non-condensing
Dimensions	44(H) x 440(W) x 173(D) mm