HP 3100 Series User Manual

198
To configure MRP timers:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use one of the commands.
3. Configure the LeaveAll timer.
mrp timer leaveall
timer-value
Optional.
The default setting is 1000
centiseconds.
4. Configure the Join timer.
mrp timer join
timer-value
Optional.
The default setting is 20
centiseconds.
5. Configure the Leave timer.
mrp timer leave
timer-value
Optional.
The default setting is 60
centiseconds.
6. Configure the Periodic timer.
mrp timer periodic
timer-value
Optional.
The default setting is 100
centiseconds.
Table 28 shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
• If you set a timer to a value beyond the allowed value range, your configuration will fail. To do
that, you can change the allowed value range by tuning the value of another related timer.
• To restore the default settings of the timers, restore the Join timer first, followed by the Leave
and LeaveAll timers.
Table 28 Dependencies of the Join, Leave, and LeaveAll timers
Timer Lower limit Upper limit
Join 20 centiseconds Half the Leave timer
Leave Twice the Join timer LeaveAll timer
LeaveAll Leave timer on each port 32760 centiseconds
NOTE:
You can restore the Periodic timer to the default at any time.
Enabling GVRP compatibility
MVRP can be compatible with GVRP. When the peer device supports GVRP, you can enable GVRP
compatibility on the local end, so that the local end can receive and send MVRP and GVRP protocol
packets at the same time.

HP 3100 Series Specifications

General

Layer	Layer 2
Jumbo Frame Support	Yes
Switching Capacity	8.8 Gbps
MAC Address Table Size	8000 entries
Management	Web interface, SNMP, CLI
Operating Temperature	0 to 45°C (32 to 113°F)
Operating Humidity	10% to 90% non-condensing
Dimensions	44(H) x 440(W) x 173(D) mm