HP 3100 Series User Manual

40
Step Command
2. Enter Layer 2 aggregate interface
view.
interface bridge-aggregation
interface-number
3. Restore the default settings for the
aggregate interface.
default
Configuring load sharing for link aggregation
groups
Configuring load-sharing criteria for link aggregation groups
You can determine how traffic is load-shared in a link aggregation group by configuring load sharing
criteria. The criteria can be source/destination MAC addresses, source/destination IP addresses, or
any combination.
NOTE:
The load sharing criteria configuration applies to only unicast packets, and can change the load
sharing criteria for unicast packets. Broadcast packets and multicast packets always use the default
load sharing criteria.
Configuring the global link-aggregation load sharing criteria
Step Command Remarks
1. Enter system
view.
system-view
N/A
2. Configure the
global
link-aggregatio
n load-sharing
criteria.
link-aggregation load-sharing
mode
{
destination-ip
|
destination-mac
|
source-ip
|
source-mac
} *
By default, the system selects the global load
sharing criteria according to the packet type.
In system view, the switch supports the following load sharing criteria and combinations:
• Load sharing criteria automatically determined based on the packet type
• Source IP address
• Destination IP address
• Source MAC address
• Destination MAC address
• Source IP address and destination IP address
• Source MAC address and destination MAC address
Displaying and maintaining Ethernet link
aggregation

HP 3100 Series Specifications

General

Brand	HP
Model	3100 Series
Category	Switch
Language	English