111
Step Command Remarks
2. Enter
interface
view or port
group view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
• Enter port group view:
port-group manual
port-group-name
Use any command.
• The configuration made in Layer 2
Ethernet interface view applies only to
the port.
• The configuration made in port group
view applies to all ports in the port group.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
3. Configure
the link type
of the ports
as trunk.
port link-type
trunk
By default, all ports are access ports.
To change the link type of a port from trunk to
hybrid or vice versa, you must set the link type
to access first.
4. Assign the
trunk ports to
the specified
VLANs.
port trunk permit vlan
{ vlan-list |
all
}
By default, a trunk port carries only VLAN 1.
5. Configure
the PVID of
the trunk
ports.
port trunk pvid vlan
vlan-id
Optional.
By default, the PVID is VLAN 1.
NOTE:
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to
configure the trunk port to allow packets from the PVID to pass through, so that the egress port can
forward packets from the PVID.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including
Ethernet interface view, and Layer 2 aggregate interface view) or port group view.
To assign a hybrid port to one or multiple VLANs:
Step Command Remarks
1. Enter system
view.
system-view
N/A
To Next Page
Loading...
Need help?
General
