EasyManuals Logo

HP 3100 Series User Manual

HP 3100 Series
225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
182
Step Command Remarks
2. Enter Ethernet interface
view or port group view.
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
Enter port group view:
port-group manual port-group-name
N/A
3. Set the LLDP operating
mode.
lldp admin-status
{
disable
|
rx
|
tx
|
txrx
}
Optional.
TxRx by default.
Setting the LLDP reinitialization delay
When LLDP operating mode changes on a port, the port initializes the protocol state machines after
an LLDP reinitialization delay. By adjusting the delay, you can avoid frequent initializations caused by
frequent changes to the LLDP operating mode on a port.
To set the LLDP reinitialization delay for ports:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the LLDP reinitialization
delay.
lldp timer reinit-delay
delay
Optional.
The default setting is 2 seconds.
Enabling LLDP polling
With LLDP polling enabled, a device periodically searches for local configuration changes. When the
device detects a configuration change, it sends LLDP frames to inform neighboring devices of the
change.
To enable LLDP polling:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view or port group view.
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
Enter port group view:
port-group manual port-group-name
N/A
3. Enable LLDP polling
and set the polling
interval.
lldp check-change-interval
interval
Disabled by default.
Configuring the advertisable TLVs
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view or port group view.
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
Enter port group view:
port-group manual port-group-name
N/A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 3100 Series and is the answer not in the manual?

HP 3100 Series Specifications

General IconGeneral
LayerLayer 2
Jumbo Frame SupportYes
Switching Capacity8.8 Gbps
MAC Address Table Size8000 entries
ManagementWeb interface, SNMP, CLI
Operating Temperature0 to 45°C (32 to 113°F)
Operating Humidity10% to 90% non-condensing
Dimensions44(H) x 440(W) x 173(D) mm

Related product manuals