214
Index
A B C D E G I L M N O P Q R S T V
A
Accessing Hewlett Packard Enterprise Support,211
Acce
ssing updates,211
Advertisin
g the voice VLAN information to IP
phones,124
Assig
ning a port to the isolation group,46
Automatically
identifying IP phones through
LLDP,124
B
BPDU tunn
eling configuration examples,100
C
Config
uration example for MVRP in normal
registration mode,199
Config
uration guidelines,18
Config
uration prerequisites,196
Config
uration prerequisites,128
Config
uration procedure,18
Config
uration restrictions and guidelines,35
Config
uring a combo interface,1
Config
uring a loopback interface,15
Config
uring a null interface,16
Config
uring a port group,7
Config
uring a port to operate in automatic voice
VLAN assignment mode,129
Config
uring a port to operate in manual voice VLAN
assignment mode,130
Config
uring a voice VLAN on a port,125
Config
uring an aggregate interface,38
Config
uring an aggregation group,35
Config
uring an MST region,65
Config
uring basic settings of a VLAN interface,106
Config
uring basic settings of an Ethernet interface,1
Config
uring basic VLAN settings,106
Config
uring CDP compatibility (available only on the
HPE 3100 v2 EI),185
Config
uring destination multicast MAC address for
BPDUs,100
Config
uring Digest Snooping,79
Config
uring edge ports,71
Config
uring flow control on an Ethernet interface,4
Config
uring GVRP functions,141
Config
uring jumbo frame support,7
Config
uring link state change suppression on an
Ethernet interface,5
Config
uring LLDP to advertise a specific voice
VLAN,132
Config
uring LLDP trapping,187
Config
uring load sharing for link aggregation
groups,40
Config
uring loopback testing on an Ethernet
interface,6
Config
uring MAC Information mode,27
Config
uring MAC-based VLANs,114
Config
uring many-to-one VLAN mapping,170
Config
uring MRP timers,197
Config
uring No Agreement Check,81
Config
uring one-to-one VLAN mapping with a global
QoS policy,166
Config
uring one-to-one VLAN mapping with port
QoS policies,168
Config
uring path costs of ports,72
Config
uring port-based VLANs,107
Config
uring protection functions,84
Config
uring protocol-based VLANs (available only
on the HPE 3100 v2 EI),118
Config
uring QoS priority settings for voice traffic on
an interface,128
Config
uring selective QinQ (available only on the
HPE 3100 v2 EI),153
Config
uring spanning tree timers,69
Config
uring static, dynamic, and blackhole MAC
address table entries,20
Config
uring storm control on an Ethernet
interface,12
Config
uring storm suppression,8
Config
uring TC snooping,83
Config
uring the aging timer for dynamic MAC
address entries,22
Config
uring the device priority,68
Config
uring the GARP timers,142
Config
uring the interval for sending Syslog or trap
messages,27
Config
uring the MAC Information queue length,27
Config
uring the MAC learning limit on ports,23
Config
uring the maximum hops of an MST region,68
Config
uring the maximum port rate,71
Config
uring the mode a port uses to recognize/send
MSTP packets,76
Config
uring the MVRP registration mode,197
Config
uring the network diameter of a switched
network,69