HP 3100 Series - Page 213

204
Verifying the configuration
1. Verify the normal registration mode configuration:
Use the display mvrp running-status command to display the local MVRP VLAN information
to verify whether the configuration takes effect.
# Check the local VLAN information on Device A.
[DeviceA] display mvrp running-status
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[Ethernet1/0/1]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default),
----[Ethernet1/0/2]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default),
----[Ethernet1/0/3]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default), 20,
The output shows that:
{ Ports Ethernet 1/0/1 and Ethernet1/0/2 have learned only VLAN 1 through MVRP.
{ Port Ethernet 1/0/3 has learned VLAN 1 and dynamic VLAN 20 created on Device B through
MVRP.
# Check the local VLAN information on Device B.
[DeviceB] display mvrp running-status