233
Step Command Remarks
4. Specify the VLAN to which the
HABP client belongs.
habp client vlan vlan-id
Optional
By default, an HABP client belongs
to VLAN 1.
The VLAN to which an HABP client
belongs must be the same as that
specified on the HABP server for
transmitting HABP packets.
Displaying and maintaining HABP
Task Command Remarks
Display HABP configuration
information.
display habp [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display HABP MAC address table
entries.
display habp table [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Display HABP packet statistics.
display habp traffic [ | { begin |
exclude | include }
regular-expression ]
Available in any view
HABP configuration example
Network requirements
As shown in Figure 76, Switch A is attached with access devices Switch B and Switch C. 802.1X
authentication is configured on Switch A for central authentication and management of users (Host A
through Host D).
For communication between Switch B and Switch C, enable HABP server on Switch A, enable HABP
client on Switch B and Switch C, and specify VLAN 1 for HABP packets.
Configure the HABP server to send HABP request packets to the HABP clients in VLAN 1 at an interval
of 50 seconds.
To Next Page
Loading...
Need help?
General
