408
[SwitchA-GigabitEthernet1/0/2] mac-forced-forwarding network-port
4. Configure Switch B:
# Configure manual-mode MFF.
[SwitchB] vlan 100
[SwitchB-vlan-100] mac-forced-forwarding default-gateway 10.1.1.100
# Specify the IP address of the server.
[SwitchB-vlan-100] mac-forced-forwarding server 10.1.1.200
# Enable ARP snooping.
[SwitchB-vlan-100] arp-snooping enable
[SwitchB-vlan-100] quit
# Configure GigabitEthernet 1/0/6 as a network port.
[SwitchB] interface gigabitethernet 1/0/6
[SwitchB-GigabitEthernet1/0/6] mac-forced-forwarding network-port
Manual-mode MFF configuration example in a ring network
Network requirements
As shown in Figure 134, all the devices are in VLAN 100, and the switches form a ring. Host A, Host B,
and Host C are configured with IP addresses manually. They are isolated at Layer 2, and can
communicate with each other through the gateway. To ensure communication between hosts and the
server, the IP address of the server is specified on the MFF devices manually.
Figure 134 Network diagram
Configuration procedure
1. Configure IP addresses of the hosts, as in shown in Figure 134.
2. Configure the IP address of VLAN-interface 1 on the gateway.
<Gateway> system-view
[Gateway] interface Vlan-interface 1
[Gateway-Vlan-interface1] ip address 10.1.1.100 24
3. Configure Switch A:
# Enable STP.
[SwitchA] stp enable
To Next Page
Loading...
