348
Task Command Remarks
Display SSL server policy
information.
display ssl server-policy
{ policy-name | all } [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Display SSL client policy
information.
display ssl client-policy
{ policy-name | all } [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Troubleshooting SSL
Symptom
As the SSL server, the switch fails to handshake with the SSL client.
Analysis
SSL handshake failure may result from the following causes:
• The SSL client is configured to authenticate the SSL server, but the SSL server has no certificate or the
certificate is not trusted.
• The SSL server is configured to authenticate the SSL client, but the SSL client has no certificate or the
certificate is not trusted.
• The server and the client have no matching cipher suite.
Solution
1. Issue the debugging ssl command and view the debugging information to locate the problem:
{ If the SSL client is configured to authenticate the SSL server but the SSL server has no certificate,
request one for it.
{ If the server’s certificate cannot be trusted, install the root certificate of the CA that issued the
local certificate to the SSL server on the SSL client, or let the server request a certificate from the
CA that the SSL client trusts.
{ If the SSL server is configured to authenticate the client, but the SSL client has no certificate or
the certificate cannot be trusted, request and install a certificate for the client.
2. Use the display ssl server-policy command to view the cipher suites that the SSL server policy
supports. If the server and the client have no matching cipher suite, use the ciphersuite command
to modify the cipher suite configuration of the SSL server.
To Next Page
Loading...
Need help?
General
