83
• If the network has 802.1X clients that cannot exchange handshake packets with the network access
device, disable the online user handshake function to prevent their connections from being
inappropriately torn down.
Configuration procedure
To configure the online user handshake function:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Set the handshake timer.
dot1x timer handshake-period
handshake-period-value
Optional.
The default is 15 seconds.
3. Enter Ethernet interface view.
interface interface-type
interface-number
N/A
4. Enable the online handshake
function.
dot1x handshake
Optional.
By default, the function is enabled.
5. Enable the online handshake
security function.
dot1x handshake secure
Optional.
By default, the function is disabled.
Configuring the authentication trigger function
The authentication trigger function enables the network access device to initiate 802.1X authentication
when 802.1X clients cannot initiate authentication.
This function provides the following types of authentication trigger:
• Multicast trigger—Periodically multicasts Identity EAP-Request packets out of a port to detect 802.1X
clients and trigger authentication.
• Unicast trigger—Enables the network device to initiate 802.1X authentication when it receives a
data frame from an unknown source MAC address. The device sends a unicast Identity
EAP/Request packet to the unknown source MAC address, and retransmits the packet if it has
received no response within a period of time. This process continues until the maximum number of
request attempts set with the dot1x retry command (see "Setting the maximum number of
a
uthentication request attempts") is reached.
The identity request timeout timer sets both the identity request interval for the multicast trigger and the
identity request timeout interval for the unicast trigger.
Configuration guidelines
Follow these guidelines when you configure the authentication trigger function:
• Enable the multicast trigger on a port when the clients attached to the port cannot send EAPOL-Start
packets to initiate 802.1X authentication.
• Enable the unicast trigger on a port if only a few 802.1X clients are attached to the port and these
clients cannot initiate authentication.
• To avoid duplicate authentication packets, do not enable both triggers on a port.
To Next Page
Loading...
Need help?
General
