HP 5528A User Manual

Message
Pl Error
P2 E rror
P3 Error
PA Error
Pr Error
Sl Error
Model 5528A
Errors and Error M essa ges
Ta bl e 1 7-1. l aser Measuremenr Systcm Error Mcss<lges (Con/inued)
Me a nin g Ac tion
Error in valuc from Material Te m- The oper il ling temperat ur e of the material
perature Se n so r N umber 1 temper at ure se n so r specified is out of its
range, or there is a fault in the material se n-
Err or in va lue from Material Tem-
so r. Remo ve the bad sensor and verify that
perature Se nsor Number 2 the error co ndition goes away. If so, ha ve
it repaired. If not , the Displ ay ma y need
Error in va lue from Material Tem-
servicing.
perature Se ns or Number 3
The se e rror s c an be cleared w ithout l oss of
measureme nt inform at i on by remov ing the
bad sensor.
Path Error - Measurement Path
Mak e s ur e the Beam strength meter on the
return beam ha s been interrup ted. Meas ur e ment Displ ay point s to the green
region over the entire length of the meas-
urement travel.
If not , impro ve the align-
m en t. The beam mu st no t be broken at any
lime during Ih e m eas urement , and the B ea m
Strength meter must
not p oi nt into the red
region, or, PA Error will appear and mea s ur e-
ment data will be lo st.
This e rror c an o nl y be cleared by reselling
the Measurement Display, dnd results in a
l oss of measurement dat a.
Programming error The MC, lS urement Display ha s re ce ived an
HP-IU
command that II do e~ n ' T recognize,
or a mi suse of an allowed commdnd. Care-
fully check your programming instructions
and
ref er 10 the Service Manual for prop er
sy nt ax and application.
This error c an be cleared, wiThout lo ss of
mea su reme nt data, by pre ss ing any key on
the keyboard (except the R ESET kt!y).
Signal l oss error . May in di cate ra te Make s ur e the o pti cs do no t exceed I he
of Opt ic movement ( during vc1o-
rated maximum ve lociti es s hown in th is User 's
cily measuremen t) is too high , or Guide, in each M eas ur eme nt Sec Tion . Al so
there is a problem in the meas ur e-
make sure the Be am Strength meter on the
ment path.
Mea s urement Display point s to the "g r een"
region over the entire length of the meas ur e-
ment travel. If nOI, impr ove the a lignm ent.
The Beam Strength meter must nol po int
i nto the red region at any t im e durin g a
measurement.
This error c an only be cleared by resett ing
the Displ ay, and r es ults in a l os!> of meas ur e-
ment data.
17-3

HP 5528A Specifications

General

Brand	HP
Model	5528A
Category	Measuring Instruments
Language	English