HP 5528A User Manual

Mode l SS28A
Errors and Error Messagcs
Table 17 -1 la se r Measuremenl Sys lcm Error Messagcs (Col1linued)
Message Meaning A dio n
Sr E rr or Sample Rate too high You are requesting sampled data over the
HP·IB ( via AUTO RECORD) faster than the
Display
can calcu late new values to display.
Refer to the Service Manual Specifications
for mcasurement mode updalc rale informa-
tior,. You mu st not exceed these rates with
yo ur AUTO RECORD time interval.
This error can be deared withoul loss of
measuremen! data by pressing any key on
the keyboard (excepl the RESET key ).
55 Error Failed parI of Measurement Di s· Cycle Ihe power switch on the Measurement
play Power-up Se lf-Test
Displ ay . If the error condition persis ts, unpl ug
all cables from the rear of the Display, one
by one, and cycle the power each time. In
Ihis
way you can determine which, if any , of
the external se n so rs or the l aser head are
ca using Ihe prob lem. If the error condil i on
persisls with all external cables disconnected.
have Ihe Measuremcnl Display repaired.
This error ca nnot be cleared and a mea sure·
ment cannot be made unle~s an action taken
above results in its removal from the Display.
Ur Error Underrange
error.
The value
;,
Pre ss the key again and the di spl ay will s how
smaller
( 0'
more negative) than you the minimum allowable va lue for Ihal
allowetl.
key. Enter a value grealer than the minimum .
17-4

HP 5528A Specifications

General

Brand	HP
Model	5528A
Category	Measuring Instruments
Language	English