HP 5900 Configuration Guide

6
Ste
p
Command Remarks
2. Create an IPv4 advanced ACL
and enter its view.
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv4 advanced ACLs are
numbered in the range of 3000 to
3999.
You can use the acl name acl-name
command to enter the view of a
named ACL.
3. (Optional.) Configure a
description for the IPv4
advanced ACL.
description text
By default, an IPv4 advanced ACL
has no ACL description.
4. (Optional.) Set the rule
numbering step.
step step-value The default setting is 5.
5. Create or edit a rule.
rule [ rule-id ] { deny | permit }
protocol [ { { ack ack-value | fin
fin-value | psh psh-value | rst
rst-value | syn syn-value | urg
urg-value } * | established } |
counting | destination
{ dest-address dest-wildcard |
any } | destination-port operator
port1 [ port2 ] | { dscp dscp |
{ precedence precedence | tos tos }
* } | fragment | icmp-type
{ icmp-type [ icmp-code ] |
icmp-message } | logging | source
{ source-address source-wildcard |
any } | source-port operator port1
[ port2 ] |
time-range
time-range-name | vpn-instance
vpn-instance-name ] *
By default, an IPv4 advanced ACL
does not contain any rule.
The logging keyword takes effect
only when the module (for
example, packet filtering) that uses
the ACL supports logging.
When an ACL is used for QoS
traffic classification or packet
filtering, the ACL does not
supported the vpn-instance
keyword or the operator neq.
6. (Optional.) Add or edit a rule
comment.
rule rule-id comment text
By default, no rule comments are
configured.
Configuring an IPv6 advanced ACL
IPv6 advanced ACLs match packets based on the source IPv6 addresses, destination IPv6 addresses,
packet priorities, protocols carried over IPv6, and other protocol header fields such as the TCP/UDP
source port number, TCP/UDP destination port number, ICMPv6 message type, and ICMPv6 message
code.
Compared to IPv6 basic ACLs, IPv6 advanced ACLs allow more flexible and accurate filtering.
To configure an IPv6 advanced ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant