HP 5900 - Align and Calibrate Cartridges; Automatically Clean Print Cartridges

46
queue in a WFQ group and then the traffic beyond the minimum guaranteed bandwidths for the queues
in the WFQ group according to the configured weights. The two WFQ groups are scheduled at a 1:1
ratio.
Configuration approaches and task list
To achieve congestion management, perform the following tasks:
Tasks at a
g
lance
(Required.) Perform one of the following tasks to configure per-queue congestion management:
• Configuring SP queuing
• Configuring WRR queuing
• Configuring WFQ queuing
• Configuring SP+WRR queuing
• Configuring SP+WFQ queuing
Configuring SP queuing
Configuration procedure
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure SP queuing.
qos sp
The default queuing algorithm on an
interface is WRR queuing.
Configuration example
Configure Ten-GigabitEthernet 1/0/1 to use SP queuing:
# Enter system view
<Sysname> system-view
# Configure Ten-GigabitEthernet1/0/1 to use SP queuing.
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos sp
Configuring WRR queuing
Configuration procedure
Ste
p
Command Remarks
1. Enter system view.
system-view N/A