39
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number
N/A
3. Configure the line rate
for the interface.
qos lr { inbound | outbound } cir
committed-information-rate [ cbs
committed-burst-size ]
By default, line rate is not
configured on an interface.
Displaying and maintaining traffic policing, GTS,
and line rate
Execute display commands in any view.
Task Command
Display QoS and ACL resource usage.
display qos-acl resource [ slot slot-number ]
Display traffic behavior configuration
information.
display traffic behavior user-defined [ behavior-name ]
Display GTS configuration and statistics on
an interface.
display qos gts interface [ interface-type interface-number ]
Display line rate configuration and statistics
on an interface.
display qos lr interface [ interface-type interface-number ]
For more information about the display qos-acl resource command, see ACL and QoS Command
Reference.
Traffic policing configuration example
Network requirements
As shown in Figure 12:
• Ten-GigabitEthernet 1/0/3 of Device A is connected to Ten-GigabitEthernet1/0/1 of Device B.
• Server, Host A, and Host B can access the Internet through Device A and Device B.
Perform traffic control on Ten-GigabitEthernet 1/0/1 of Device A for traffic received from Server and
Host A, respectively, to satisfy the following requirements:
• Limit the rate of traffic from Server to 102400 kbps: Transmit the conforming traffic normally, mark
the excess traffic with DSCP value 0, and then transmit the traffic.
• Limit the rate of traffic from Host A to 25600 kbps: Transmit the conforming traffic normally, and
drop the excess traffic.
Perform traffic control on Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 of Device B to
satisfy the following requirements:
• Limit the total incoming traffic rate of Ten-GigabitEthernet 1/0/1 to 204800 kbps and drop the
excess traffic.
To Next Page
Loading...
Need help?
General
