EasyManuals Logo

HP 5900 Configuration Guide

HP 5900
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
38
Ste
p
Command
Remarks
6. Configure a traffic
policing action.
car cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ pir
peak-information-rate ] [ green action |
red action | yellow action ] *
By default, no traffic policing action is
configured.
7. Return to system view.
quit N/A
8. Create a QoS policy
and enter QoS policy
view.
qos policy policy-name
By default, no QoS policy is
configured.
9. Associate the traffic
class with the traffic
behavior in the QoS
policy.
classifier classifier-name behavior
behavior-name
By default, a traffic class is not
associated with a traffic behavior.
10. Return to system view.
quit N/A
11. Apply the QoS policy.
Applying the QoS policy to an
interface
Applying the QoS policy to a VLAN
Applying the QoS policy globally
Applying the QoS policy to the
control plane
Choose one of the application
destinations as needed.
By default, no QoS policy is applied.
12. (Optional.) Display
traffic policing
configuration
information.
display traffic behavior user-defined
[ behavior-name ]
Available in any view.
Configuring GTS
The switch supports configuring queue-based GTS by using the non-MQC approach. In queue-based
GTS, you set GTS parameters for packets of a certain queue.
To configure GTS:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure GTS for a
queue.
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ]
By default, GTS is not configured
on an interface.
Configuring the line rate
The line rate of a physical interface specifies the maximum rate of incoming packets or outgoing packets.
To configure the line rate:

Table of Contents

Other manuals for HP 5900

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5900 and is the answer not in the manual?

HP 5900 Specifications

General IconGeneral
ModelHP 5900
Rack MountableYes
MAC Address Table Size128K
Jumbo Frame SupportYes
Routing ProtocolOSPF, BGP, RIP, IS-IS, IGMP
Remote Management ProtocolSNMP, CLI
FeaturesQuality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature0 °C to 45 °C
Operating Humidity10% to 90% non-condensing
Power SupplyInternal power supply - hot-plug / redundant

Related product manuals