HP 5900 - Print Test Page and Check Ink Levels

47
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable WRR queuing.
qos wrr { byte-count | weight }
The default queuing algorithm on an
interface is byte-count WRR queuing.
4. Configure a WRR
queue.
qos wrr queue-id group { 1 | 2 }
{ byte-count | weight }
schedule-value
Select an approach according to the WRR
queuing type.
By default, all queues are in group 1, and
the weights of queues 0 through 7 are 1, 2,
3, 4, 5, 9, 13, and 15, respectively.
Configuration example
Network requirements
Enable packet-based WRR on port Ten-GigabitEthernet 1/0/1, assign queues 0 through 3 to WRR
group 1, with their weights being 1, 2, 4, 6, respectively, and assign queues 4 through 7 to WRR group
2, with their weights being 1, 2, 4, 6, respectively.
Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure WRR queuing on Ten-GigabitEthernet 1/0/1.
[Sysname] interface Ten-GigabitEthernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr weight
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 1
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 1 group 1 weight 2
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 2 group 1 weight 4
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 6
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 4 group 2 weight 1
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 5 group 2 weight 2
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 6 group 2 weight 4
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 7 group 2 weight 6
Configuring WFQ queuing
Configuration procedure
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable WFQ queuing.
qos wfq { byte-count | weight }
The default queuing algorithm on an
interface is WRR queuing.