22
protocol group type to identify the type of packets sent to the control plane. You can reference
protocol types or protocol group types in if-match commands in traffic class view for traffic
classification and then re-configure traffic behaviors for these traffic classes as required. You can
use the display qos policy control-plane pre-defined command to display them.
• If a QoS policy applied to the control plane uses if-match control-plane protocol-group or if-match
control-plane protocol for traffic classification in a class, the action in the associated traffic behavior
can only be car or the combination of car and accounting packet, and only the cir keyword in the
car action can be applied normally.
Configuration procedure
To apply the QoS policy to the control plane:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter control plane view.
control-plane slot slot-number
N/A
3. Apply the QoS policy to
the control plane.
qos apply policy policy-name inbound
By default, no QoS policy
is applied to a control
plane.
Displaying and maintaining QoS policies
Execute display commands in any view and reset commands in user view.
Task Command
Display traffic class configuration.
display traffic classifier user-defined [ classifier-name ]
Display traffic behavior configuration.
display traffic behavior user-defined [ behavior-name ]
Display QoS and ACL resource usage. display qos-acl resource [ slot slot-number ]
Display user-defined QoS policy
configuration.
display qos policy user-defined [ policy-name [ classifier
classifier-name ] ]
Display QoS policy configuration on the
specified or all interfaces.
display qos policy interface [ interface-type interface-number ]
[ inbound | outbound ]
Display information about QoS policies
applied to VLANs.
display qos vlan-policy { name policy-name | vlan vlan-id } [ slot
slot-number ] [ inbound | outbound ]
Display information about QoS policies
applied globally.
display qos policy global [ slot slot-number ] [ inbound |
outbound ]
Display information about QoS policies
applied to a control plane.
display qos policy control-plane slot slot-number [ inbound |
outbound ]
Display information about the pre-defined
QoS policy applied to the control plane.
display qos policy control-plane pre-defined [ slot slot-number ]
Clear the statistics of the QoS policy
applied in a certain direction of a VLAN.
reset qos vlan-policy [ vlan vlan-id ] [ inbound | outbound ]
To Next Page
Loading...
Need help?
General
