18
Table 2 Available match criteria
O
tion Descri
tion
acl [ ipv6 ] { acl-number | name
acl-name }
Matches an ACL.
The acl-number argument is in the range of 2000 to 3999 for an IPv4 ACL,
2000 to 3999 for an IPv6 ACL, and 4000 to 4999 for an Ethernet frame
header ACL.
The acl-name argument is a case-insensitive string of 1 to 63 characters,
which must start with an English letter, and to avoid confusion, it cannot be
all.
any Matches all packets.
control-plane protocol
protocol-name&<1-8>
Matches the control plane protocols.
The protocol-name-list&<1-8> argument is a list of system-defined control
plane protocols. &<1-8> indicates that you can enter up to eight
system-defined control plane protocols.
control-plane protocol-group
protocol-group-name
Matches the control plane protocol group.
The protocol-group-name argument can be critical, important, monitor, or
normal.
customer-dot1p
dot1p-value&<1-8>
Matches the 802.1p priority of the customer network.
The dot1p-value&<1-8> argument is a list of 802.1p priority values. An
802.1p priority is in the range of 0 to 7. &<1-8> indicates that you can enter
up to eight 802.1p priority values.
customer-vlan-id vlan-id-list
Matches the customer VLAN IDs (CVLANs).
The vlan-id-list argument is in the format of vlan-id-list = { vlan-id | vlan-id1 to
vlan-id2 }&<1-10>, where the vlan-id, vlan-id1, and vlan-id2 arguments
represent the VLAN IDs and each are in the range of 1 to 4094, vlan-id1
must be no greater than vlan-id2, and &<1-10> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges.
destination-mac mac-address Matches a destination MAC address.
dscp dscp-value&<1-8>
Matches DSCP values.
The dscp-value&<1-8> argument is a list of DSCP values. A DSCP value is in
the range of 0 to 63 or can be a keyword shown Table 11. &<1-8> indicates
that you can enter up to eight DSCP values.
ip-precedence
ip-precedence-value&<1-8>
Matches IP precedence.
The ip-precedence-value&<1-8> argument is a list of IP precedence values.
An IP precedence is in the range of 0 to 7. &<1-8> indicates that you can
enter up to eight IP precedence values.
protocol protocol-name
Matches a protocol.
The protocol-name argument can be ARP, IP, or IPv6.
qos-local-id local-id-value
Matches a local QoS ID in the range of 1 to 4095.
The switch supports local QoS IDs in the range of 1 to 3999.
service-dot1p
dot1p-value&<1-8>
Matches the 802.1p priority of the service provider network.
The dot1p-value&<1-8> argument is a list of 802.1p priority values. An
802.1p priority is in the range of 0 to 7. &<1-8> indicates that you can enter
up to eight 802.1p priority values.
To Next Page
Loading...
Need help?
General
