HP 5900 Configuration Guide

83
Figure 26 Network diagram
Configuration procedure
# Create a periodic time range during 8:00 and 18:00 on working days from June 2011 to the end of
the year.
<DeviceA> system-view
[DeviceA] time-range work 08:00 to 18:00 working-day from 00:00 6/1/2011 to 24:00
12/31/2011
# Create an IPv4 basic ACL numbered 2001, and configure a rule in the ACL to permit only packets from
192.168.1.2/32 during the time range work.
[DeviceA] acl number 2001
[DeviceA-acl-basic-2001] rule permit source 192.168.1.2 0 time-range work
[DeviceA-acl-basic-2001] rule deny source any time-range work
[DeviceA-acl-basic-2001] quit
# Apply IPv4 basic ACL 2001 to filter outgoing packets on interface Ten-GigabitEthernet 1/0/2.
[DeviceA] interface ten-gigabitethernet 1/0/2
[DeviceA-Ten-GigabitEthernet1/0/2] packet-filter 2001 outbound
[DeviceA-Ten-GigabitEthernet1/0/2] quit
Verifying the configuration
# Display time range configuration and status on Device A.
[DeviceA] display time-range all
Current time is 13:58:35 5/20/2011 Friday
Time-range : work (Active)
08:00 to 18:00 working-day
from 00:00 6/1/2011 to 00:00 1/1/2012
The output shows that the time range work is active.

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant