HP 83751A User Manual

I
-
I
-
Instrument State Keys
Alternate sweep is turned off by selecting m ALT n again.
I
I
NOTE
If ALT SI.~.I~ Reg=<n> is not the active parameter (with pointers above it), then the key
sequence m 1Msc;l must be performed twice to turn off alternate sweep.
NOTE
If the attenuator setting in the selected register differs from the current setting, then the current
setting is used and the MSG annunciator is lit, and an error message is displayed.
Associated SCPI Commands
:SYSTem:ALTernate <n>
S.&cts the instrument state in
register <n> as the lktrument
state to be afternated wkh the
current state.
SYSTem:ALTernate:STATe:ON
Turns on the alternate sweep
function.
SYSTem:ALTernate:STATe:OFF
Turns off the alternate sweep
function.
AL1 -Cn>
Associated 8350 Commands
Turns alternate sweep on, and
se&s the instrument state stored
in register <n> as the state to be
ahernated wkh the current state.
AL0
Turns off the afternate sweep
function.
8-12

HP 83751A Specifications

General

Brand	HP
Model	83751A
Category	Blower
Language	English