I
-
Marker Keys
@KG]
Associated SCPI Commands
MARKer[n]
[:STATe]
ON
Same as pressing the
[MKR
n]
ker
MARKer[n]:FREQuency
Enters fiequenq of
marke/:
Guun>Csuffixl
Associated 8350 Commands
M
<n>
<num>[suffix]
Same as pressing [[MKR
nJ
kel
MA
<num>[suffix]
Used to set marker 0.
MKR
MODE
When this function is selected (by pressing
[WI
[EGG]),
the current
marker output format is displayed. The mode can be changed to the next
choice by pressing the
@
@J
keys, or by selecting
(?FiiFi~
MKR
MODE again.
The marker output format choices are:
Amplitude
In this mode the on markers appear as a rise of about
1
dl3
in the output power. The displayed message is
Mat-1;
et-s=Rpjp
1
it.
IJS~~.
Intensity
In this mode the on markers appear as a
-5V
pulse at the
Z-AXIS
BLANK/MKRS
rear panel output connector. The
displayed message is
Markers=In~.ensity.
NOTE
The Z-axis markers are always on, so it is not possible to have amplitude markers on, and intensity
markers off.
9-5
-1
I-
To Next Page
Loading...