I
-
I
-
Frequency Keys
0
cw
Pressing the
a
key sets the instrument to CW (continuous wave) mode and
allows the CW frequency to be changed.
This key turns the sweep mode off, and displays the CW frequency in the
FREQUENCY display. (The right half of the FREQUENCY display is blanked.)
The CW Annunciator is turned on. The CW frequency becomes the active
parameter. If marker sweep mode is on, it will be turned off.
CWKF
The CW frequency can be set independently of Start/Stop/CF/Span, or can be
Coupling
coupled to them, depending on whether CWKF Coupling is turned on or off.
CWXF coupling is turned off in the factory preset condition. When coupling
is turned on, CW=CF.
To turn on CWKF coupling:
Press
key(s):
(SHIFT)
SPECXAL
(iJ
[Hz/sIENTER]
GD
Display reads:
Last special function accessed.
iI:i.,.i~:f’
AlAt,
o=OFF
1:
,.,,I
1:
f
H
IA t..
0
=
0
1.1
Associated SCPI Commands
FREquency:MODE
CWlFIXed
Sets the instrument to CW mode.
FRECjuency[:CWIFIXed]:AUTO
ON
kns
the
CWkenter
frequenq
couphkg
on.
FREQuency[:CWIFIXed]:AUTO
OFF
Turns the
CW/kenter
frequenq
coupling
of/
FREquency:CWIFIXed
<num>[suffix]
Sets the CWfiequenq to the
desired value.
Associated 8350 Commands
CW
<num>Csuff
ix1
Sets the
CW
frequenq to the
desired value.
1
l-10
To Next Page
Loading...
General