I
-
I
-
Special Functions
17 -*SECURITY
402 CLRMEM This function lets you set the number of times that the
RAMS
will be cleared
COUNT
and initialized to zeros with the clear memory function.
When you press
@FiiF)
SPECIAL
@
[Hz/s/ENTER_), the following message is
displayed:
C
It-Mem
Courtt.=
1.
The
0)
(7JJ
keys or the front panel knob let
you change the count. Or use the numeric keypad to enter the new value.
Numbers between and including 1 through 20 are accepted.
The clear memory count is reset to a value of one at preset or when power is
cycled on the instrument.
Associated SCPI Commands
SYSTem:SECurity:
COUNt
<nun>
1
MIN
1
MAX
Sets the numberoftimes that
RAM
are
inriiabbd
to
zeros.
403 SAVE This function allows you to enable or disable the
CRAVE)
function. When the
LOCK
function is enabled, you can save instrument states into the nine available
registers using the
LSAVE)
key. When the function is disabled, you cannot
save instrument states, and the message
!91’4E
LOCKECi
! ! will appear in the
MARKER/SWEEP/STATUS display if you attempt to do so.
When your instrument was shipped, the save function was enabled.
When you press
[SHIFT_)
SPECIAL
@
[HZ/S/ENTER
, the following message is
displayed:
SHrr’Ekel~=Enatlle~~.
The
0J
@)
keys or the front panel knob let
you toggle between enabled and disabled.
If you disable this function, it will stay disabled (through presets and power
cycles) until you enable it again using this special function.
Associated SCPI Commands
SYSTem:KEY:ENABle SAVE
EnabLes
the
[SAVE/
ker
SYSTem:KEY:DISaBle SAVE
Disabbs
the [SAVEJ
kel
15-24
To Next Page
Loading...
General