HP 83751A - Page 208

I
-
Error Messages
SCPI Error Messages
- 123
“Exponent too large”
-124
The magnitude of the exponent was larger than 32000. (See IEEE
488.2, 7.7.2.4.1).
“Too many digits”
The mantissa of a decimal numeric data element contained
more than 255 digits excluding leading zeros. (See IEEE 488.2,
7.7.2.4.1).
-128
- 130
“Numeric data not allowed”
A legal numeric data element was received, but the device does not
accept one in this position for the header.
“ SdEx error”
-131
This error, as well as errors - 131 through - 139, are generated
when parsing a sufhx. This particular error message should be
used if the device cannot detect a more specific error.
“Invalid sufhx”
-134
The sufhx does not follow the syntax described in IEEE 488.2,
7.7.3.2, or the sufhx is inappropriate for this device.
“SufEx too long”
-138
The suffix contained more than 12 characters. (See IEEE 488.2,
7.7.3.4).
“Suffix not allowed”
-140
-141
A suffix was encountered after a numeric element which does not
allow suffixes.
“Character data error”
This error, as well as errors -141 through -149, are generated
when parsing a character data element. This particular error
message should be used if the device cannot detect a more specific
error.
“Invalid character data”
Either the character data element contains an invalid character or
the particular element received is not valid for the header.
16-10