HP 8924C - Page 348

Index
348
S:\HP8924C\USRGUIDE\BOOK\24cug.IX
S
save
instrument setups, 61
settings, 61
SAVE key
using, 61
Save/Recall Registers
default mass storage locations, 217
saving instrument setups, 61
saving settings, 61
screen dump, 71
screens
interactions, 69
printing, 71
setting intensity, 44
Serial 1 Status Register Group, 187
Serial 2 Status Register Group, 192
serial port
cables/adapters for, 247
configuration, 246, 251, 282
input buffer length, 252
interface to IBASIC controller, 246
receive/transmit pacing, 252
select code 10, 247, 282, 284
select code 9, 247, 251, 282
serial I/O from IBASIC program, 282
Service Request Enable Register, 201
clearing, 206
reading, 204
writing, 205
Service Requests
Service Request Enable Register (see
Service Request EnableRegister),
201
settings
base, 64
beeper volume, 45
changing, field, 26
date, 45
default, 63, 64
power-on, 63
recalling, 61
RF voltage, 44
saving, 61
time, 45
setups
recalling, 61
saving, 61
SRAM Memory card, 210, 215
Standard Event Status Register Group,
197
accessing registers contained in, 200
bit assignments, 199
Status Byte Register, 201
clearing, 204
reading with serial poll, 203
reading with STB Common Command,
203
writing, 204
Status reporting, 108
clearing the Status Byte Register, 204
Condition register definition, 110
Enable register definition, 112
Event register definition, 111
Questionable Data/Signal Register
Group (see QuestionableData/Sig-
nal Register Group), 182
reading Status Byte Register with serial
poll, 203
reading Status Byte Register with STB
CommonCommand, 203
Standard Event Status Register Group
(see Standard EventStatus Register
Group), 197
Status Byte Register, 201
status queue model, 113
status register model, 109
status register structure overview, 108
status registers in Test Set, 116
Summary Message definition, 112
Transition filter definition, 110
writing the Status Byte Register, 204
Storing code files, 224
Support Contacts
electronic mail, 9
HP Desk, 9
telephone, 9
System Controller, 95
T
terminal configuration, 260
Test Set
default file system, 208
display units - changing, 55
file name conflicts, 222
file system, 220
file types, 223
HP-IB units - changing, 56
operating modes, 23
overview, 30
STATe command - definition, 49
status registers, 116
test set
configuring, 43
TESTS Subsystem, 306
default mass storage locations, 218
file descriptions, 307
file relationships, 308
screens, 309
TestSet
file name entry field width, 221
file names (see also DOS & LIF file
names), 221
Time
Configure screen, 45
time and date, 45
triggering
measurement triggering process, 72
triggering analog measurements in lo-
cal mode, 76
triggering analog measurements in re-
mote mode, 82
triggering cdma measurements in local
mode, 79
triggering cdma measurements in re-
mote mode, 84
TX Test screen
priority settings, 69