39
Ste
Command
Remarks
5. Configure the command level
for login users on the current
user interfaces.
user privilege level level
Required.
By default, the default command level is 0
for VTY user interfaces.
6. Configure common settings
for VTY user interfaces.
—
Optional.
See “Configuring common settings for VTY
user interfaces (optional).”
When you log in to the device through Telnet again:
• You enter the VTY user interface, as shown in Figure 11.
• If “A
ll user interfaces are used, please try later!” is displayed, it means the current login users exceed the
maximum number. Please try later.
Figure 11 Configuration page
To Next Page
Loading...
Need help?
General
