HP A5800 Series User Manual

43
Ste
p
Command Remarks
9. Create local user and
enter local user view.
local-user user-name By default, no local user exists.
10. Set local password.
password { cipher |
simple } password
Required.
By default, no local password is set.
11. Specify command
level of the local user.
authorization-attrib
ute level level
Optional.
By default, the command level is 0.
12. Specify service type
for the local user.
service-type telnet
Required.
By default, no service type is specified.
13. Exit to system view.
quit —
14. Configure common
settings for VTY user
interfaces.
—
Optional.
See “Configuring common settings for VTY user interfaces
(optional).”
After you enable command authorization, you must perform the following configuration to make the function
take effect:
• Create a HWTACACS scheme, and specify the IP address of the authorization server and other
authorization parameters. For more information, see Security Configuration Guide.
• Reference the created HWTACACS scheme in the ISP domain. For more information, see Security
Configuration Guide.
After you enable command accounting, you must perform the following configuration to make the function
take effect:
• Create a HWTACACS scheme, and specify the IP address of the accounting server and other
accounting parameters. For more information, see Security Configuration Guide.
• Reference the created HWTACACS scheme in the ISP domain. For more information, see Security
Configuration Guide.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
• When the AAA scheme is local, the user privilege level is defined by the authorization-attribute level
level.
• When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the RADIUS
or HWTACACS server.
For more information about AAA, RADIUS, and HWTACACS, see Security Configuration Guide.
When you log in to the device through Telnet again:
• You are required to enter the login username and password. A prompt such as <HP> appears after you
enter the correct username (for example, admin) and password and press Enter, as shown in
Figure 13.
• A
f
ter entering the correct username and password, if the device prompts you to enter another password
of the specified type, you will be authenticated for the second time. In other words, to pass
authentication, you must enter a correct password as prompted.
• If “All user interfaces are used, please try later!” is displayed, it means the current login users exceed the
maximum number. Please try later.

HP A5800 Series Specifications

General

Brand	HP
Model	A5800 Series
Category	Switch
Language	English