54
6.
Character string CONNECT9600 is displayed on the terminal. Then a prompt appears when you
press Enter.
Figure 6 Configuration page
7. If the authentication mode is password, a prompt (for example, HP) appears when you enter the
configured password on the remote terminal. Then configure or manage the router. To get help,
enter ?.
8. Execute commands to configure the device or check the running status of the device. To get help,
enter ?.
NOTE:
• To terminate the connection between the PC and device, run ATH command on the terminal to terminate
the connection between the PC and modem. If you cannot execute the command on the terminal, enter
AT+ + + and then press Enter. When you are prompted OK, run ATH, and the connection is terminated
if OK is displayed. Alternately, terminate the connection between the PC and device by clicking on
the hyper terminal window.
• Do not close the hyper terminal directly. Otherwise, the remote modem remains online, and you will fail
to dial in at the next time.
Modem login authentication modes
The following authentication modes are available for modem dial-in login: none, password, and scheme.
• none—Requires no username and password at the next login through modems. This mode is insecure.
• password—Requires password authentication at the next login through the console port. Keep your
password.
• scheme—Requires username and password authentication at the next login through the console port.
Authentication falls into local authentication and remote authentication. To use local authentication,
configure a local user and related parameters. To use remote authentication, configure the username and
To Next Page
Loading...
Need help?
General
