69
2. Configuration on the PC
# On the PC, run the web browser. Enter the IP address of the device in the address bar, 192.168.20.66 in
this example. The web login page appears, as shown in Figure 4.
Figure 4 Web login page
# Enter the user name, password, verify code, select English, and click Login. The homepage appears. After
login, configure device settings through the web interface.
HTTPS login example
Network requirements
As shown in Figure 5, to prevent unauthorized users from accessing the Device, configure HTTPS login as
follows:
• Configure the Device as the HTTPS server, and request a certificate for it.
• The Host acts as the HTTPS client. Request a certificate for it.
In this example, Windows Server acts as the CA. Install Simple Certificate Enrollment Protocol (SCEP) add-on
on the CA. The name of the CA that issues certificates to the Device and Host is new-ca.
Before performing the following configuration, make sure that the Device, Host, and CA can reach each
other.
To Next Page
Loading...
Need help?
General
