HP A5800 Series User Manual

51
Procedure
Configure other settings for the SSH client to work with the SSH server. For more information, see Security
Configuration Guide. To configure the SSH client to log in to the SSH server:
Ste
p
Command Remarks
Log in to an IPv4 SSH server. ssh2 server
Required
server is the IPv4 address or host name of the server.
Available in user view
Log in to an IPv6 SSH server. ssh2 ipv6 server
Required
server is the IPv6 address or host name of the server.
Available in user view
Logging in through modems
The administrator can use two modems to remotely maintain a switch through its Console port over the Public
Switched Telephone Network (PSTN) when the IP network connection is broken.
Configuration requirements
By default, no authentication is needed when you log in through modems, and the default user privilege level
is 3.
To use this method, perform necessary configurations at both the device side and administrator side.
The following table shows the configuration requirements of remote login through the console port by using
modem dial-in:
Ob
j
ect Re
q
uirement
Administrator side
The PC is correctly connected to the modem.
The modem is connected to a telephone cable that works normally.
The telephone number of the remote modem connected to the Console port of the
remote switch is obtained.
Device side
The Console port is correctly connected to the modem.
Configurations have been configured on the modem.
The modem is connected to a telephone cable that works properly.
Authentication configuration has been completed on the remote switch.

HP A5800 Series Specifications

General

Brand	HP
Model	A5800 Series
Category	Switch
Language	English