38 Performing basic configuration tasks
For the SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32, Brocade 4Gb SAN Switch for HP
p-Class BladeSystem, and SAN Switch 4/32: The following example shows the command as executed on
a SAN Switch 2/32. The output is similar on SAN Switch 2/8V, SAN Switch 2/16V, Brocade 4Gb SAN
Switch for HP p-Class BladeSystem, and SAN Switch 4/32:
:
For the Core Switch 2/64, SAN Director 2/128, and 4/256 SAN Director: Command output includes
parameters related to CP blades.
switch:admin> switchstatuspolicyset
To change the overall switch status policy parameters
The current overall switch status policy parameters:
Down Marginal
----------------------------------
FaultyPorts 2 1
MissingSFPs 0 0
PowerSupplies 2 1
Temperatures 2 1
Fans 2 1
PortStatus 0 0
ISLStatus 0 0
Note that the value, 0, for a parameter, means that it is
NOT used in the calculation.
** In addition, if the range of settable values in the prompt is (0..0),
** the policy parameter is NOT applicable to the switch.
** Simply hit the Return key.
The minimum number of
FaultyPorts contributing to
DOWN status: (0..32) [2] 3
FaultyPorts contributing to
MARGINAL status: (0..32) [1] 2
MissingSFPs contributing to
DOWN status: (0..32) [0]
MissingSFPs contributing to
MARGINAL status: (0..32) [0]
Bad PowerSupplies contributing to
DOWN status: (0..2) [2]
Bad PowerSupplies contributing to
MARGINAL status: (0..2) [1]
Bad Temperatures contributing to
DOWN status: (0..5) [2]
Bad Temperatures contributing to
MARGINAL status: (0..5) [1]
Bad Fans contributing to
DOWN status: (0..6) [2]
Bad Fans contributing to
MARGINAL status: (0..6) [1]
Down PortStatus contributing to
DOWN status: (0..32) [0]
Down PortStatus contributing to
MARGINAL status: (0..32) [0]
down ISLStatus contributing to
DOWN status: (0..32) [0]
down ISLStatus contributing to
MARGINAL status: (0..32) [0]
Policy parameter set has been changed
To Next Page
Loading...
