• The DSAP optioins specified in the DSAPCSTM file are taken as default. That is, the options
specified in the DSAPCSTM file are appended to the DSAP command you specify at the TACL
prompt.
• The DSAPCSTM file exists in the DEFAULT VOL-SUBVOL of the user running DSAP.
• DSAP creates the DSAPCSTM file in your DEFAULT VOL-SUBVOL the first time you run DSAP
or when the file has been purged.
• If the DSAPCSTM is already in your DEFAULT VOL-SUBVOL, DSAP reads information from
this file.
• DSAP closes the custom file after reading it.
For usage guidelines, see Guidelines: Running DSAP (page 99).
116 Disk Space Analysis Program (DSAP)
To Next Page
Loading...
