Rear Chassis Fan
1. Prepare the computer for disassembly (Preparation for Disassembly on page 60).
2. Remove the computer access panel (
Computer Access Panel on page 64).
3. Disconnect the fan control cable from the system board.
4. Press down on the two upper tabs (1) to loosen the fan housing from the chassis.
5. Rotate the fan forward (2), and then lift it up and out of the chassis (3).
To install the fan assembly, reverse the removal procedure. Be sure to orient the air flow out of the unit.
Rear Chassis Fan 95
To Next Page
Loading...
