EasyManuals Logo

HP Compaq dc7800 User Manual

HP Compaq dc7800
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #225 background imageLoading...
Page #225 background image
Activity Beeps Possible Cause Recommended Action
Red Power LED flashes three
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
3 Processor not installed
(not an indicator of bad
processor).
1. Check to see that the processor is present.
2. Reseat the processor.
Red Power LED flashes four
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
4 Power failure (power
supply is overloaded).
OR
The incorrect external
power supply adapter is
being used on the USDT.
1. Open the hood and ensure the 4 or 6-wire
power supply cable is seated into the
connector on the system board.
2. Check if a device is causing the problem by
removing ALL attached devices (such as
hard, diskette, or optical drives, and
expansion cards). Power on the system. If
the system enters the POST, then power off
and replace one device at a time and repeat
this procedure until failure occurs. Replace
the device that is causing the failure.
Continue adding devices one at a time to
ensure all devices are functioning properly.
3. Replace the power supply.
4. Replace the system board.
OR
The USDT power supply adapter must be at 135W
and use the Smart ID technology before the
system will power up. Replace the power supply
adapter with the HP-supplied USDT power supply
adapter.
Red Power LED flashes five
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
5 Pre-video memory error. CAUTION: To avoid damage to the DIMMs or
the system board, you must unplug the computer
power cord before attempting to reseat, install, or
remove a DIMM module.
1. Reseat DIMMs.
2. Replace DIMMs one at a time to isolate the
faulty module.
3. Replace third-party memory with HP
memory.
4. Replace the system board.
Red Power LED flashes six
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
6 Pre-video graphics error. For systems with a graphics card:
1. Reseat the graphics card.
2. Replace the graphics card.
3. Replace the system board.
For systems with integrated graphics, replace the
system board.
Red Power LED flashes seven
times, once every second,
followed by a two second
pause. Beeps stop after fifth
7 System board failure
(ROM detected failure
prior to video).
Replace the system board.
Table C-2 Diagnostic Front Panel LEDs and Audible Codes (continued)
Interpreting POST Diagnostic Front Panel LEDs and Audible Codes 213

Table of Contents

Other manuals for HP Compaq dc7800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq dc7800 and is the answer not in the manual?

HP Compaq dc7800 Specifications

General IconGeneral
Tcase73.3 °C
Bus typeFSB
SteppingM0
Processor cache2 MB
Processor cores2
Processor modelE4600
System bus rate- GT/s
Processor familyIntel® Core™2 Duo
Processor seriesIntel Core 2 Duo E4000 Series
Processor socketLGA 775 (Socket T)
Processor codenameConroe
Processing Die size111 mm²
Processor frequency2.4 GHz
Processor cache typeL2
Processor lithography65 nm
Processor manufacturerIntel
Processor front side bus800 MHz
Processor operating modes64-bit
ECC supported by processorNo
Thermal Design Power (TDP)65 W
CPU multiplier (bus/core ratio)12
Number of Processing Die Transistors167 M
Internal memory1 GB
Internal memory typeDDR2-SDRAM
Maximum internal memory8 GB
Memory layout (slots x size)2 x 0.5 GB
HDD speed7200 RPM
HDD interfaceSATA
Optical drive typeDVD Super Multi
Total storage capacity160 GB
Audio input1
LightScribeYes
Networking featuresIntel 82566DM Gigabit Network Connection
Graphics card RAMDAC400 MHz
Storage drive controllerSATA 3, 0 Gb/s NCQ SMART VI
Discrete graphics card modelIntel® GMA 3100
Maximum graphics card memory0.256 GB
Operating system installedWindows Vista Business
USB 2.0 ports quantity8
Chassis typeMini Tower
Country of originChina
Cable lock slot typeKensington
Operating altitude0 - 3048 m
Non-operating altitude0 - 9144 m
Storage temperature (T-T)-30 - 60 °C
Operating temperature (T-T)10 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)10 - 90 %
Power supply365 W
Product typePC
Processor codeSLA94
Processor ARK ID32242
Processor package size37.5 x 37.5 mm
Weight and Dimensions IconWeight and Dimensions
Depth452 mm
Width177 mm
Height447 mm
Weight11800 g

Related product manuals