EasyManuals Logo

HP Compaq dc7800 User Manual

HP Compaq dc7800
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #239 background imageLoading...
Page #239 background image
Nonsystem disk/NTLDR missing message.
Cause Solution
The system is trying to start from a diskette that is not bootable. Remove the diskette from the diskette drive.
The system is trying to start from the hard drive but the hard
drive may have been damaged.
1. Insert a bootable diskette into the diskette drive and
restart the computer.
2. Check the hard drive format using fdisk: If NTFS
formatting, use a third party reader to evaluate the drive.
If FAT32 formatting, the hard drive cannot be accessed.
System files missing or not properly installed. 1. Insert a bootable diskette into the diskette drive and
restart the computer.
2. Check the hard drive format using Fdisk: If NFTFS
formatting, use a third party reader to evaluate the drive.
If FAT32 formatting, the hard drive cannot be accessed.
3. Install system files for the appropriate operating system.
Hard drive boot has been disabled in Computer Setup. Run the Computer Setup utility and enable the hard drive entry
in the Storage > Boot Order list.
Bootable hard drive is not attached as first in a multi-hard drive
configuration.
If attempting to boot from a hard drive, ensure it is attached to
the system board connector labeled P60 SATA 0.
Bootable hard drive's controller is not listed first in the Boot
Order.
Run the Computer Setup utility and select Storage > Boot
Order and ensure the bootable hard drive's controller is listed
immediately under the Hard Drive entry.
Computer will not boot from hard drive.
Cause Solution
The device is attached to a SATA port that has been hidden in
Computer Setup.
Run the Computer Setup utility and ensure Device Available
is selected for the device's SATA port in Security > Device
Security.
Boot order is not correct. Run the Computer Setup utility and change boot sequence
in Storage > Boot Order.
Hard Drive's "Emulation Type" is set to "None." Run the Computer Setup utility and change the "Emulation
Type" to "Hard Disk" in the device's details under Storage >
Device Configuration.
Hard drive is damaged. Observe if the front panel Power LED is blinking RED and if
any beeps are heard. See
POST Error Messages
on page 205 to determine possible causes for the blinking red
and beep codes.
See the Worldwide Limited Warranty for terms and conditions.
Computer seems to be locked up.
Cause
Solution
Program in use has stopped responding to commands. Attempt the normal Windows “Shut Down” procedure. If this
fails, press the power button for four or more seconds to turn
Table D-4 Solving Hard Drive Problems (continued)
Solving Hard Drive Problems 227

Table of Contents

Other manuals for HP Compaq dc7800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq dc7800 and is the answer not in the manual?

HP Compaq dc7800 Specifications

General IconGeneral
Tcase73.3 °C
Bus typeFSB
SteppingM0
Processor cache2 MB
Processor cores2
Processor modelE4600
System bus rate- GT/s
Processor familyIntel® Core™2 Duo
Processor seriesIntel Core 2 Duo E4000 Series
Processor socketLGA 775 (Socket T)
Processor codenameConroe
Processing Die size111 mm²
Processor frequency2.4 GHz
Processor cache typeL2
Processor lithography65 nm
Processor manufacturerIntel
Processor front side bus800 MHz
Processor operating modes64-bit
ECC supported by processorNo
Thermal Design Power (TDP)65 W
CPU multiplier (bus/core ratio)12
Number of Processing Die Transistors167 M
Internal memory1 GB
Internal memory typeDDR2-SDRAM
Maximum internal memory8 GB
Memory layout (slots x size)2 x 0.5 GB
HDD speed7200 RPM
HDD interfaceSATA
Optical drive typeDVD Super Multi
Total storage capacity160 GB
Audio input1
LightScribeYes
Networking featuresIntel 82566DM Gigabit Network Connection
Graphics card RAMDAC400 MHz
Storage drive controllerSATA 3, 0 Gb/s NCQ SMART VI
Discrete graphics card modelIntel® GMA 3100
Maximum graphics card memory0.256 GB
Operating system installedWindows Vista Business
USB 2.0 ports quantity8
Chassis typeMini Tower
Country of originChina
Cable lock slot typeKensington
Operating altitude0 - 3048 m
Non-operating altitude0 - 9144 m
Storage temperature (T-T)-30 - 60 °C
Operating temperature (T-T)10 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)10 - 90 %
Power supply365 W
Product typePC
Processor codeSLA94
Processor ARK ID32242
Processor package size37.5 x 37.5 mm
Weight and Dimensions IconWeight and Dimensions
Depth452 mm
Width177 mm
Height447 mm
Weight11800 g

Related product manuals