6. Pull up on the green hard drive drivelock mechanism (1) for that drive and slide the drive from the
drive bay (2).
7. Remove the four guide screws (two on each side) from the old drive and install them in the
replacement drive.
NOTE: Extra 6-32 isolation guide screws are provided on the hard drive bracket under the access
panel. Optical drives use M3 metric screws. The HP-supplied metric screws are black.
8. Store the removed drive in anti-static packaging.
9. Install the new drive by sliding it into the appropriate drive bay on the front of the chassis. The
drivelock automatically secures the drive in the bay.
Drives 81
To Next Page
Loading...
