Updating BIOS when installing a display panel for a different manufacturer
If you install a display panel from a different manufacturer than what was previously installed (for
example, replace an LG panel with a Samsung panel), you need to update BIOS with the new panel
information. Failure to do so may cause the new panel to function incorrectly.
To update BIOS with the new panel model information:
1. Boot the computer.
2. Repeatedly press F10 when the monitor light turns green to access the F10 Setup utility.
3. Select Advanced, select Device Options, select LVDS Panel Select, and then select the
manufacturer for the new display panel.
4. Save your settings, exit F10 Setup, and allow the computer to continue to the operating system.
5. Reboot the computer and repeatedly press F10 when the monitor light turns green to access the
F10 Setup utility.
6. Select Advanced, select Device Options, and then select LVDS Panel Select.
7. Select Auto-select.
When you change the LVDS setting to the installed panel type, the BIOS reprograms the EDID with the
correct data. You must set the panel before the Auto-select setting functions correctly.
Display panel
117
To Next Page
Loading...
Need help?
General
