HP D300 - Page 69

HP D300 Digital Dispenser
69
Table 6-1 Error message guide
Error message text
Error message title
Recommended action
Unable to send! Some data are not in the correct
format.
Data Format Error
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser and then restart
the software
Unable to start dispensing this split. (Already
dispensing.)
Dispense Error
Wait until the dispenser is finished
dispensing and retry if necessary.
Unable to start dispensing this split. (Invalid
Dispensehead number.)
Dispense Error
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser, restart the
software, and retry the configuration.
Unable to start dispensing this split. (Lost
comms?)
Dispense Error
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser, restart the
software, and retry the configuration
after deleting wells that have already
been dispensed.
Unable to start dispensing this split. (Unknown
plate type.)
Dispense Error
Save the configuration, close the
software, and turn the dispenser off.
Restart the dispenser, restart the
software, and retry the configuration.