To install the network driver before starting the Disaster Recovery, use the New
Hardware Wizard, which can be invoked with the following command:
%SystemRoot%\system32\rundll32 shell32.dll,Control_RunDLL
hdwwiz.cpl
• You may use the default ASR (DHCP) network installation.
Follow the normal ASR procedure and press F8 when the following text is displayed
in the Disaster Recovery wizard: Press F8 in the next 5 seconds to
skip network configuration...
This will revert from Data Protector ASR network configuration to the standard
Microsoft ASR network configuration.
Troubleshooting disaster recovery148
To Next Page
Loading...
