HP DL360 Maintenance And Service Guide

Removal and Replacement Procedures
To remove the optical device:
1. Press the Power On/Standby switch to place the server in standby mode. Refer to
“Powering Down the Server” earlier in this chapter.
2. Push the optical device ejector button to release the optical device (1).
NOTE: Access to the optical device ejector button is intentionally restricted. Push the optical
device ejector button with a small flat object such as a key or pen to eject the optical drive.
3. Grasp the optical device and remove it from the optical device bay (2).
Figure 2-11: Removing the optical device
2-14 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide

HP DL360 Specifications

General

Brand	HP
Model	DL360
Category	Server
Language	English