HP DL360 Maintenance And Service Guide

LEDs, Switches, and Jumpers
Switches
The system board contains three switchbanks that may need to be modified to set
configuration or to trigger special functions. These switches can cause problems if they are
not correctly set.
When adding or removing a component or changing a security feature, the server must be
reconfigured to recognize these changes. If the system configuration is incorrect, the server
may not work properly, and you may receive error messages on the screen.
IMPORTANT: Reserved switches are provided for use by HP authorized service providers
only and should not be changed from the indicated default settings.
Refer to Figure 5-3 and Table 5-3 for locations on the system board of the switches.
The following subsections provide reference information about setting the system board
switches and jumpers, which is part of the reconfiguration process, along with running the
ROM-Based Setup Utility (RBSU).
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 5-5

HP DL360 Specifications

General

Processor Sockets	2
CPU	Intel Xeon Scalable
Memory	Up to 3TB DDR4
Form Factor	1U Rack
Power Supply	Redundant Power Supplies, various wattage options
Network Controller	Embedded 1Gb or 10Gb Ethernet
RAID Support	Smart Array RAID
Operating System Support	Windows Server, Linux, VMware
Storage	Up to 10 SFF SAS/SATA/NVMe drives or 4 LFF SAS/SATA drives