To Next Page

To Previous Page

Removal and Replacement Procedures

To replace the hard drive:

1. Slide the hard drive into the open bay (1).

2. Close the drive latch to secure the hard drive into the server (2).

Figure 2-10: Installing a hot-plug U320 SCSI hard drive

Optical Device

The server supports a diskette drive and an optical device. The optical device and the diskette

drive may be removed independently.

CAUTION: Do not operate the server without an optical device installed. Failure to install an

optical device can lead to improper cooling and may damage the system.

HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 2-13

Other manuals for HP DL360

Questions and Answers:

Need help?

Do you have a question about the HP DL360 and is the answer not in the manual?

General

Processor Sockets	2
CPU	Intel Xeon Scalable
Memory	Up to 3TB DDR4
Form Factor	1U Rack
Power Supply	Redundant Power Supplies, various wattage options
Network Controller	Embedded 1Gb or 10Gb Ethernet
RAID Support	Smart Array RAID
Operating System Support	Windows Server, Linux, VMware
Storage	Up to 10 SFF SAS/SATA/NVMe drives or 4 LFF SAS/SATA drives