HP DL370 - ProLiant - G6 Performance - Page 61

Hardware options installation 61
o
Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 22).
o Extend the server from the rack (on page 24).
3. Remove the access panel (on page 25).
4. Remove the air baffle (on page 26).
5. Remove the fan cage (on page 26).
6. Remove any SFF hard drives, if installed.
7. Disconnect the power and data cables from the eight-bay SFF drive cage in drive cage bay 1.
8. Using a T-10 Torx screwdriver, remove the eight-bay SFF drive cage from drive cage bay 1.
9. Using a T-15 Torx screwdriver, install the six-bay LFF backplane.