Hardware options installation 63
Installing the six-bay LFF backplane (bay 2)
To install the component:
1. Power down the server (on page 22).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 22).
o Extend the server from the rack (on page 24).
3. Remove the access panel (on page 25).
4. Remove the air baffle (on page 26).
5. Remove the fan cage (on page 26).
6. Remove the hard drive cage blank (on page 28).
7. Using a T-15 Torx screwdriver, install the six-bay LFF backplane.
8. Connect the power cable.
To Next Page
Loading...
