HP DL370 - ProLiant - G6 Performance - Installing a Full-Height Media Device

Hardware options installation 70
Installing a full-height media device
1. Power down the server (on page 22).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 22).
o Extend the server from the rack (on page 24).
3. Remove the access panel (on page 25).
4. Remove the air baffle (on page 26).
5. Remove the fan cage (on page 26).
6. Remove the media bay blank (on page 27).
7. Remove the DVD-ROM drive (on page 28).
8. Using a T-15 Torx screwdriver, remove the screws from the blank and install them on the device.
9. Slide the media device part of the way into the bay.