Hardware options installation 66
10.
Using a T-15 Torx screwdriver, install the locking brackets.
11. Connect the drive cage bay 3 power cable (BP3) to the two-bay LFF drive cage backplane.
12. Connect the two-bay LFF drive cage to one of the following:
o A six-bay LFF backplane. See step 13.
o An optional SAS controller. See step 14.
13. Connect the SAS/SATA controller cable:
a. Connect the "6LFF" labeled connector to SAS connector 5-6 on the six-bay LFF backplane.
b. Connect the "2LFF" labeled connector to the two-bay LFF drive cage backplane.
To Next Page
Loading...
