HP Dragonfly Folio User Manual

2. Loosen the eight captive Phillips screws (2) that secure the heat sink and fans to the computer.
3. Remove the antenna cable from the tape and clips around the right fan (3).
4. Lift the left side of the heat sink up to approximately 45°, and then pull it to the left and out of the
computer. (4).
5. Thoroughly clean the thermal material from the surfaces of the heat sink and the system board
components each time the heat sink is removed. The following illustration shows the replacement
thermal material location.
NOTE: If a thermal pad is not present in replacement heat sink kit, reuse the old thermal pad during the
replacement.
To install the heat sink, reverse this procedure.
The replacement heat sink comes with a thermal pad installed on the bottom of the section that extends over
the WWAN module.
48
Chapter 5Removal and replacement procedures for authorized service provider parts

HP Dragonfly Folio Specifications

General

Graphics	Intel Iris Xe Graphics
Processor	12th Gen Intel Core i5 or i7
RAM	16 GB or 32 GB LPDDR5
Storage	512 GB, 1 TB, or 2 TB PCIe NVMe SSD
Operating System	Windows 11 Pro
Wireless	Intel Wi-Fi 6E AX211 (2x2) and Bluetooth 5.2
Ports	1 x Headphone/microphone combo
Audio	quad speakers
Security	Fingerprint reader, TPM 2.0
Weight	Starting at 2.99 lb (1.35 kg)