EasyManuals Logo

HP Elite 7500 Microtower User Manual

HP Elite 7500 Microtower
230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #214 background imageLoading...
Page #214 background image
Resetting the Password Jumper – Model 7300/7500
To disable the power-on or setup password features, or to clear the power-on or setup passwords,
complete the following steps:
1. Shut down the operating system properly, then turn off the computer and any external devices,
and disconnect the power cord from the power outlet.
2. With the power cord disconnected, press the power button again to drain the system of any
residual power.
WARNING! To reduce the risk of personal injury from electrical shock and/or hot surfaces, be
sure to disconnect the power cord from the wall outlet, and allow the internal system
components to cool before touching.
CAUTION: When the computer is plugged in, the power supply always has voltage applied to
the system board even when the unit is turned off. Failure to disconnect the power cord can
result in damage to the system.
Static electricity can damage the electronic components of the computer or optional equipment.
Before beginning these procedures, ensure that you are discharged of static electricity by briefly
touching a grounded metal object. See the Safety & Regulatory Information guide for more
information.
3. Remove the access panel.
4. Locate the CMOS/password header.
NOTE: The password jumper is blue so that it can be easily identified. For assistance locating
the password jumper and other system board components, see the Illustrated Parts & Service
Map (IPSM). The IPSM can be downloaded from
http://www.hp.com/support.
5. Remove the jumper from pins 5 and 3.
6. Place the jumper on pins 3 or 1 for 10-15 seconds.
7. Put the jumper back on pins 5 or 3.
8. Replace the access panel.
9. Reconnect the external equipment.
10. Plug in the computer and turn on power. Allow the operating system to start.
11. To establish new passwords, use Computer Setup.
204 Appendix E Password Security and Resetting CMOS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Elite 7500 Microtower and is the answer not in the manual?

HP Elite 7500 Microtower Specifications

General IconGeneral
Form FactorMicrotower
ProcessorIntel Core i5 or i7 (varies by model)
RAMUp to 32 GB
StorageUp to 2 TB HDD or 256 GB SSD
GraphicsIntegrated Intel HD Graphics or optional discrete graphics
Optical DriveDVD-ROM
AudioHigh Definition Audio
NetworkingGigabit Ethernet
PortsUSB 2.0, USB 3.0, Audio In/Out, VGA, DisplayPort
Operating SystemWindows 7 Professional
Power Supply300W
Expansion Slots1 PCIe x16, 1 PCIe x1, 1 PCI

Related product manuals